Products

Home > Products200watts Liquid to Liquid Type Thermoelectric Power Generator, good for waste heat recovery.

The 200 watts thermoelectric generator runs with circulated heat transfer oil which distributes the heat to each thermoelectric module (TEM) to generate electricity. The cooling of the generator is by using 30 °C water, which brings out the heat that passes through the modules effectively. The generator is good for waste heat recovery.

The thermoelectric power generator consists of thermoelectric modules, hot oil pipe for hot oil circulating to bring the heat to each module, water pipe for water circulating to bring out the heat. The hot oil flows from bottom of the generator to bring the heat to all the hot sides of the modules and out from the top cooling oil outlet. The water flows from the cooling water inlet in the bottom, pass the modules cold side to bring out the heat that flows through the modules, and then out from the top cooling water outlet.

The generator is installed with 16pcs 56 mm × 56 mm modules. It can generate over 200 watts if the heat source is over 300 and 30 °C cooling water flow-in is in 1.2 liters/ min on one inlet.

 

Please down load the specification from here in PDF TEG200-24V
TEG200-48V

南粤36选7彩票开奖 炒股软件排名 加拿大快乐8在线玩 河内五分彩的技巧方法 赛车pk10永久稳赢技巧 广东11选五开奖结果一定牛 内蒙十一选五跨度走势 河南11选五5官方 期货配资禁止性规定 查询快乐十分的开奖结果 江苏体彩七位数开奖走势图